Default Configuration; Data Connections; Ethernet Switch; Connecting The Wwan Antenna (Rf Connectors) - Alcatel-Lucent OA5725R Installation Manual

Table of Contents

Advertisement

3 Components and Power Supply
(3) The device will begin the restart with LEDs S and C off and LED L in green.

3.4.2 Default Configuration

Follow these steps to install the default configuration:
(1) Press the RST button. Device restart is indicated by the 3 LEDs on the front panel lighting up in amber.
(2) Keep pressing the RST button. The S LED will flash green while you are still pressing the RST button. This
state implies that the device configuration has changed to the default configuration.
(3) Stop pressing the RST button to allow the device to restart.
(4) The device will begin the restart with LEDs S and C off and LED L in green.
(5) As the device now has the default configuration, you can access it through the IP bearing in mind that the de-
fault address for the equipment is 192.168.1.1, and that it is accessible from any switch port.

3.5 Data Connections

The OA5725R router family has the following data connectors:

3.5.1 Ethernet Switch

The OA5725R family incorporates a 6 port Switch, 10/100 BaseT with automatic MDI/MDIX to connect to the LAN.
This has a 100 LED to indicate connection at 100 Mbps and a LNK LED indicating the physical connection.
LAN switch ports (6)
Fig. 10:

3.5.2 Connecting the WWAN Antenna (RF connectors)

The OA5725R routers have two connectors for RF antennas. To assemble and disassemble the antennas, simply
screw them into the connectors labeled as RF1/RF2 (located on the front panel of the device).
The RF1 connector is connected to the module's MAIN connector and the RF2 connector to the AUX connector in
the same module. This configuration means you can use diverse techniques to improve the quality of the radio con-
nection (valid for HSDPA, HSUPA, HSPA+ and LTE technologies).
Installing an antenna in the OA5725R routers is necessary to improve the quality of the signal received and transmit-
ted by the WWAN module (GPRS, UMTS, HSDPA, HSUPA, etc.).
WWAN antenna connectors
Fig. 11:
12
Alcatel-Lucent Enterprise
OA5725R Router

Advertisement

Table of Contents
loading

Table of Contents