Fujitsu AB*G45LRTA series Design & Technical Manual page 26

CONTENTS OF FUNCTION SETTING
„ „
• Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
• The settings may be selected between the following two: Function Number or Setting Value.
• Settings will not be changed if invalid numbers or setting values are selected.
1)
2)
3)
4)
5)
6)
7)
8)
9) Room temperature sensor switching (Aux.)
10) Indoor unit fan control for energy saving for cooling
1) Filter sign
Select appropriate intervals for displaying the filter sign on the indoor unit according to the
estimated amount of dust in the air of the room.
If the indication is not required, select "No indication" (03).
Setting Description
"Standard
(2,500 hours)"
"Long interval
(4,400 hours)"
"Short interval
(1,250 hours)"
No indication

2) Ceiling height
Select the appropriate ceiling height according to the place of installation.
Setting Description
Standard

(2.5m to 3.0m)
High ceiling
(3.0m or more)
3) Room temperature control for cooling
Depending on the installed environment, correction of the room temperature sensor may be
required.
Select the appropriate control setting according to the installed environment..
Setting Description
Standard

Slightly lower control
Lower control
Higher control
Filter sign
Ceiling height
Room temperature control for cooling
Room temperature control for heating
Auto restart
Room temperature sensor switching
Remote controller custom code
External input control
Function Number
11
Function Number
20
Function Number
30
(  . . .Factory setting)
Setting Value
00
01
02
03
(  . . .Factory setting)
Setting Value
00
01
(  . . .Factory setting)
Setting Value
00
01
02
03
- (01 - 23) -