Selecting Demo Mode - Honeywell KMD-150 Pilot's Manual

Getting Started
SET UP: Allows Setup of map, NAV, PIN and input/output characteris-
tics.
MAP: This is the primary mode of the unit.
Stormscope mode is switched on and off on this screen using the joy-
stick.
As a rule, when trying to get to a specific function in another branch of
software you should work your way back up the present branch to MAIN
MENU by pressing the PREV PAGE or MAIN MENU keys. Then select
the branch of software that contains the desired function you wish to
access. There are, however, short cuts allowing you to get to the primary
mode, MAP mode, more easily. GPS STATUS is replaced with DATA
IN/OUT if the unit is set to receive external GPS data. In this case the
unit will automatically be configured to accept data from the external
GPS/LORAN.

SELECTING DEMO MODE

Demo Mode allows you
to become familiar with
handling your unit on the
ground by turning it into a
simulator. Demo Mode
can only be activated in
the first title screen, avail-
able at power on and will
automatically be disabled
if your unit receives valid
GPS data. Press DEMO
MODE in the title screen,
and use the joystick to
select the start LAT and
LONG and the ground SPEED you wish to use. Alternatively you can
press the DATABASE key and select a data point from the database as
a start point (for more information on achieving this please refer to
Database Selection in this section of the manual).
Once the desired LAT/LONG and SPEED is entered press START
DEMO.
Demo Mode is not available if the unit is set to receive external
GPS/LORAN data.
19
Rev 1 Mar/2000 KMD 150 Pilot's Guide