Table of Contents
Advertisement
KNOW YOUR EDGER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR EDG-
ER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with the
location of the various controls and adjustments. Save this manual for future reference.
Depth Adjustment Knob
Gearbox
BLADE
The BLADE is designed to cut sod.
OPERATING THE COUPLER
Your powerhead is equipped with a coupler
which enables optional attachments to be
installed. The optional attachments are:
Cultivator
. . . . . . . . . . . . . . . . .
Blower
. . . . . . . . . . . . . . . . . . . .
Brushcutter
. . . . . . . . . . . . . . .
WARNING:
Always disconnect pow-
erhead spark plug (or disconnect powerhead
from power source) before removing or instal-
ling attachments.
REMOVING ATTACHMENT
CAUTION:
When removing or installing at-
tachments, place the powerhead and attach-
ment on a flat surface for stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Upper Shaft
Coupler
LOOSEN
Lower
Attachment
TIGHTEN
OPERATION
Wheel
DEPTH ADJUSTMENT KNOB
The DEPTH ADJUSTMENT KNOB is used
to adjust the wheel for blade cutting depth.
2. Press and hold the locking/release button.
Locking/Release
Button
MODEL:
PPB2000T
PPB3000B
Lower Attachment
PPB4000C
3. While securely holding the upper shaft,
pull the attachment straight out of the cou-
pler.
INSTALLING ATTACHMENT
1. Remove the shaft cap from the attachment
(if present) and discard.
2. Position locking/release button of attach-
ment into guide recess of upper shaft cou-
pler.
Coupler Primary Hole
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
Knob
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
6
Hanger
Shaft
Blade Shield
Edger Blade
Coupler
Upper Shaft
Guide Recess
Locking/
Attachment
Upper
Release
Shaft
Button
Advertisement
Table of Contents
