Ser Vice Journal; Pre-Deliv Ery Service; After The First 25 Hours - Husqvarna P524 Operator's Manual

Pre-deliver y service
1 Charge the battery for at least 4 hours at max. 3
amp.
2 Check and adjust the air pressure in the tyres
(100 kPa, 1.0 bar, 14.5 PSI).
3 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit
should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4
mm / 1/8" higher than front edge.
Adjust cutting unit height setting so that cutting
height limit is 5 mm / 3/16" above the frame of the
unit at the lowest cutting height.
4 Check that the right amount of oil is in the engine.
5 Check that there is oil in the transmission's oil
tank.
6 Connect battery.
7 Fill with fuel and start engine.
8 Check that machine does not move in neutral.
9 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
Safety switch. For the hydrostat pedals.
10 Check the oil level in the hydraulic system. Top up
if necessary.

Ser vice journal

11 Tell customer about:
The requirement and advantages of servicing the
machine according to the service plan
Servicing and the influence of this journal on the
second-hand value of the machine.
The transmission warranty is only valid if front and
rear wheel rotation speed has be checked in
accordance with the service schedule. Adjust if
necessary according to the table values specified in the
workshop manual. Performed by authorized servicing
dealer. The system will be damaged if this adjustment is
not carried out.
At temperatures below 0 ° C, the machine must
be warmed up for at least 10 minutes for the
hydraulic oil and transmission to get hot.
Otherwise there is a risk of the transmission breaking
down thereby reducing the service life of the transmission.
Servicing and the influence of this journal on the
second-hand value of the machine.
Range of applications for BioClip function.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems.
Certified:
Date:
Mileage:
Signature:
Label:
After the fi rst 25 hours
1 Change the engine oil.
2 Changing the gearbox oil (Only AWD-machines)
3 Check front and rear wheel rotation speed
according to the service schedule. (Only AWD-
machines) See the workshop manual.
– 3
English