Setting Evf/Monitor/Sdi Surround View; Setting Evf/Monitor/Sdi Status Overlays - ARRI AMIRA User Manual

Home screen and camera menu
7.8.2

Setting EVF/Monitor/SDI surround view

The surround view shows the outer edges of the sensor image which are not
recorded. It allows you to spot and avoid unwanted objects before they enter the
image.
1. You have the following options:
°
°
2. Set the surround view on or off.
7.8.3

Setting EVF/Monitor/SDI status overlays

► You have the following options:
°
°
°
You have the following options:
°
°
°
°
°
Choose MENU > Monitoring > EVF/Monitor > Surround view.
Choose MENU > Monitoring > SDI > SDI processing > Surround view.
Choose MENU > Monitoring > EVF/Monitor > EVF overlays.
Choose MENU > Monitoring > EVF/Monitor > Monitor overlays.
Choose MENU > Monitoring > SDI > SDI processing > SDI overlays.
Frame lines
Sets frame lines on or off. Used as a framing reference tool with typically an
image frame, a center mark and aspect ratio. For information on setting frame
lines, see "Setting frame lines", page 103.
Center mark
Sets the center mark for use with frame lines between Off, Small Dot, Dot, or
Cross.
Surround mask
Sets the type of overlay to mark the surround view area of the active image.
Either as black line, colored line, or semi transparent with 25, 50 or 75 percent
opacity (opacity selection not available for monitor). The surround view area
helps with framing and is not recorded.
Status info
Only for EVF and SDI. Sets camera status overlays between Off, Overlay
(status on the active image), or Safe (status outside the active image).
Note: In Overlay mode, frame lines up to an aspect ratio of 1.94:1 are not
displayed because they are covered by the status info.
Status components
Only for EVF and SDI. Configures the status info overlay components. For
more information, see "Setting EVF/SDI status info components", page 103.
97