Tank Removal - Windsor EM-21A Instruction Manual

ELECTRA-MATIC 115V
en screws holding tank support bracket
to frame and tip tank assembly forward.
CAUTION: Be sure ELECTRA-MATIC IS
UNPLUGGED FROM WALL OUTLET AND
THAT TANKS ARE EMPTY.
TO REMOVE TANK ASSEMBLY FROM
pins from front hinges and tip off.
This digital recorder keeps track of
It
operating hours. is wired into the
vacuum motor circuit so that all opera-
tions using the vacuum are recorded.
IF YOU WILL USE AND CARE
ELECTRA-MATIC AS
IN THIS SECTION, IT WLl GIVE YOU
YEARS OF TROUBLE-FREE SERVICE.
SERVICING THE
DRAIN AND CLEAN TANKS
SOLUTION TANK
solution).
1 . Plug extension cable from machine into
properly grounded outlet.
2. Remove hose from vac shoe and pull
through guide on handle
3. Position dome on waste water tank to
allow vac hose to be lowered into
solution lank.
4. Lower vacuum lever to turn on vac
motor. Vacuum solution into waste
water tank. Use water hose to rinse
inside of tank. Reattach vac hose to
shoe when finished.
WASTE WATER TANK:
FOR YOUR
Remove drain hose from keeper on
1 .
bottom of control housing and put hose
over drain or bucket.
2 . Use water hose and detergent to clean
inside of tank.

TANK REMOVAL

1.
-
(To remove unused
2. Remove inspection plugs. Loosen
1 .
3.
2.
4. Remove front hinge pins and set tank
Page 5
Empty solution and waste water tanks.
screws holding tank support bracket
frame and tip tank assembly forward.
to
Tilt tank forward and disconnect hoses
from tank and vac motor.
aside.
o f
26
3 .
4.
5.
6.
5