Assembly - Poulan Pro HDF900 Operator's Manual

ASSEMBLY

Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
FRONT
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Utility knife
(1) Screwdriver
(2) 1/2" wrenches
LEFT
RIGHT
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
OPERATOR'S POSITION
Fig. 1
CONTENTS OF HARDWARE PACK
(2) Hex Bolts 5/16-18 x 1
(4) Washers 3/8 x 7/8 x 14
(6) Hex Nuts 5/16-18
(4) Hex Bolts 5/16-18 x 1-1/4 (6) Lock Washers 5/16
4