4 Operation
4.5
Mobile operation
Conditions: Heating installation with VRC 700 control, product with Inter-
net gateway
1
eBUS cable
2
Network cable
3
Wireless LAN connec-
tion
If the product is equipped with an Internet gateway, there is
a product identification sticker in the form of a Data Matrix
code on the back of the front flap.
The Internet gateway is used for connection to a broadband
Internet connection as a prerequisite for mobile operation via
a smartphone or tablet. The Internet gateway always estab-
lishes the connection towards the Vaillant server. External
access to the Internet gateway is not possible. Mobile use of
functions of the connected controller is possible via the Inter-
net gateway.
During installation, the competent person either established
the Internet connection via the local network using network
cables or set it up via wireless LAN (WLAN).
Conditions: Product identification sticker present
▶
Download the App for mobile operation from Google
play™ or the App Store™.
Note
Search term Vaillant
▶
Proceed as described below.
8
1
2
3
4
5
4
Ethernet- or Wire-
less LAN-compatible
DSL- (Digital Subscriber
Line) or cable router
5
Vaillant server
Conditions: Connection to the local network via network cables
▶
On the operator control panel for the heat generator, nav-
igate to the comDIALOG menu item (relates to the integ-
rated Internet gateway) and check whether the status of
the Internet gateway is Online.
–
Menu → Information → comDIALOG
▽
If the status is not Online, adjust your router configur-
ation if required and repeat the check.
◁
Status is Online.
▶
Launch the app and follow the instructions contained in it.
Conditions: Connection to the local network via WLAN
▶
Launch the app and follow the instructions contained in it.
▶
Switch the heat generator off and on again.
Note
After switching on the product, the WLAN
USB stick at the Internet gateway is initialised
and switched to Ad-hoc-Pairing mode for 10
minutes.
▶
Firstly, connect to the Internet gateway for the heat gen-
erator via WLAN Ad-hoc-Pairing and then connect the
Internet gateway to the local network infrastructure.
Note
If you cannot establish an Ad-Hoc-Pairing with
the Internet gateway within 60 seconds, repeat
the procedure after switching the heat gener-
ator on and off again.
▶
If you change the password for WLAN access to the local
network, repeat this procedure, too.
▶
On the operator control panel for the heat generator, nav-
igate to the comDIALOG menu item and check whether
the status of the Internet gateway is Online.
–
Menu → Information → comDIALOG
▽
If the status is not Online, adjust your router configur-
ation if required and repeat the check.
◁
Status is Online.
▶
Follow the further instructions in the App.
Conditions: Product identification sticker not present
Mobile operation is only possible via an external Internet
gateway, which must be purchased separately as an access-
ory.
Operating instructions ecoTEC exclusive 0020189874_03