Yamaha DX7 II FD Reference Manual page 42

CS1/CS2
The last two LCD displays allow you to program the two continuous sliders (CS 1 and
CS2). A total of 105 different parameters are available to apply with each ofthe
continuous sliders. This lets you use these sliders as very fine and flexible performance
controls.
Select The following parameters are available for selection in each of the CS screens. In the edit
mode, CS2 becomes the data entry slider which is used to select the parameter to be
affected by either of the continuous sliders back in the play mode. Using a slider
in the
edit mode to select the effect it will have in the play mode may be a bit confusing
at
first,
but you'll soon get the hang of it.
The available parameters are listed from the top to the bottom position of the data entry
slider as it is used to select them.
OP6-1 Total
1
evel
OP6-1 AMP. MOD. SENS.
OP6-1 Key Velocity
OP6-1 EG Level 4-1 (L4-L1)
OP6-1 EG Rate 4-1 (R4-R1)
OP6-1 OSC. detune
OP6-1 Frequency tine
OP6-1 Frequency coarse
Portamento time
Pitch EG Level 4-1
Pitch EG Rate 4-1
LFO A MOD. Depth
LFO P MOD. Depth
LFO P MOD. SENS.
LFO Delay time
LFO Speed
LFO Wave
Feedback level
Algorithm
Dual detune
PAN control
Output balance(A/B)
Total volume
No Effect
In the dual or split voice modes, the selected parameters can be controlled for either or
both of the A and B voices. In single mode, the A parameter must be on for CS control to
be effective. Notice that in selecting Output balance (NB), only the A parameter is turned
on and off.
-39-