Ricoh FT2260 Service Manual page 157

1 August 1988
10. Keeping the wire taut, move the 1st scanner towards the right in order to
create space around the lens drive pulley as shown.
11. Run the wire 3 and a half times around the lens drive pulley (from bottom
to top).
12. Keeping the wire taut, move the 1st scanner to its home position.
13. Pass the wire in front of the lens home position sensor and hook the ten-
sion spring [L] to its anchorage point on the lens unit drive clamp [M].
NOTE: Move the lens housing manually in order to confirm that the lens
drive wire moves smoothly and that it does not overlap at any point
on the lens drive pulley.
5-14