Table of Contents
Advertisement
■ The Projected Image Is Blurred
Cause
The image is out of
focus.
The distance to the
screen is too short.
The projector is not
placed straight in front of
the screen.
The projector has been
moved to a place where
the temperature varies a
lot.
The lens is stained.
Video is blurred.
Motion blur reduction is
not available.
■ You Cannot Project an Image Appropriately
Cause
The projected image is
inverted in the vertical or
horizontal direction.
A computer cable is
used in which some pins
are not connected.
■ The Projector Power Turns Off
Cause
The air intake or exhaust
vent is blocked.
Countermeasure
Adjust the focus. (P59)
Check whether the distance to the screen is
appropriate. (P40)
Check whether the projector is placed obliquely to
the screen. A slight error in the projection angle can
be corrected through the keystone adjustment
function. (P65)
When the projector is moved from a location where
the temperature is low to a location where the
temperature is high, condensation may form on the
lens. The condensation will evaporate after a period
of time and the projector will be able to project a
normal image.
Clean the lens. (P194)
Activate motion blur reduction. (P126)
Motion blur reduction is not available in DICOM SIM
image mode.
Countermeasure
The ceiling mounted / rear projection setting is
incorrect. Check the [Image flip H/V] setting in the
[Install settings] menu. (P108)
Use a computer cable in which all pins are
connected.
Countermeasure
Check whether the air intake or exhaust vent is
blocked. If the air intake or exhaust vent is blocked,
the temperature inside the projector will increase and
the power is automatically turned off to protect the
projector. (The [WARNING] indicator and [TEMP]
indicator are lit.) Wait until the projector temperature
drops, then make sure that the intake and exhaust
vents (P28) are not blocked and turn on the projector.
(P53)
211
Troubleshooting
Advertisement
Table of Contents
