Controlling The Projector From A Computer - Canon 4K600STZ User Manual

Controlling the Projector from a Computer

The projector can be controlled from a computer over a wired or wireless network
connection.
1
Turn on the computer and projector.
2
Launch a web browser, enter "http://(projector IP address)" in the
address bar, and press the Enter key.
The projector web screen appears.
The factory default IP address is "192.168.254.254" for wired connections and
"192.168.253.254" for wireless connections (4K600STZ/4K600Z). If DHCP settings are
used, ask the network administrator for the projector IP address. It is possible to check
the IP address from the projector menu.
3
Click [Projector control] on the web screen.
The password input window appears.
4
Enter the user name and password on the password input window, then
click [OK].
The factory default user name is "root" and the password is "system".
Using the default user name and password unchanged opens up the risk of
unauthorized operation of the projector by a malicious third party.
To enhance security, it is highly recommended that you change the user name
and password. (P163)
The projector control screen appears.
The projector can be controlled from this screen.
Item
Projector name
Comment
Refresh
Power
Input
Aspect
Image mode
Blank
The name of the connected projector is displayed. (P177)
Shows notes, such as where the projector is installed. (P177)
Refreshes the displayed contents with the most recent information.
Turns projector power on or off.
Select an input signal and click [Apply] to change to that input signal.
(P56)
Select an aspect and click [Apply] to change to that aspect. (P64)
Select an image mode and click [Apply] to change to that image mode.
(P68)
Switches the blank setting on or off. (P72)
181
Using the Projector on a Network
Explanation