Controlling The Projector From A Computer - Canon 4K500ST User Manual

Menu Settings

Controlling the Projector from a Computer

When the projector is connected to a network, it is possible to control the projector
from a computer via the network.
1
Turn on the computer and projector.
2
Launch a web browser, enter "http://(projector IP address)" in the
address bar, and press the Enter key.
The projector web screen appears.
The factory default IP address is "192.168.254.254". If DHCP settings are used, ask the
network administrator for the projector IP address. It is possible to check the IP address
from the projector menu.
3
Click [Projector control] on the web screen.
The password input window appears.
4
Enter the user name and password on the password input window, then
click [OK].
The factory default user name is "root" and the password is "system".
The projector control screen appears.
The projector can be controlled from this screen.
Item
Projector name
Comment
Refresh
Power
Input
Aspect
Image mode
Blank
Mute
The name of the connected projector is displayed. (P141)
Shows notes, such as where the projector is installed. (P141)
Refreshes the displayed contents with the most recent information.
Turns projector power on or off.
Select an input signal and click [Apply] to change to that input signal.
(P63)
Select an aspect and click [Apply] to change to that aspect. (P72)
Select an image mode and click [Apply] to change to that image mode.
(P76)
Switches the blank setting on or off. (P80)
Switches the mute setting on or off. (P31)
146
Explanation