Fiat 500x User Manual page 156

WHAT TO DO IN EMERGENCIES
Prolonged driving with the Malfunction Indicator Light (MIL) on could cause damage to
the engine control system. It also could affect fuel economy and driveability. If the MIL
is flashing, severe catalytic converter damage and power loss will soon occur. Immediate
service is required.
– SERV (Service) 4WD Indicator Light — If Equipped
If the light stays on or comes on during driving, it means that the 4WD system is not
functioning properly and that service is required. We recommend you drive to the near-
est service center and have the vehicle serviced immediately.
– Electronic Stability Control (ESC) Activation/Malfunction Indicator Light
If this indicator light flashes during acceleration, apply as little throttle as possible. While
driving, ease up on the accelerator. Adapt your speed and driving to the prevailing road
conditions. To improve the vehicle's traction when starting off in deep snow, sand or
gravel, it may be desirable to switch the ESC system off.
– Enhanced Accident Response System Warning Light
The light illuminates when there is a fuel system shut off.
– Enhanced Accident Response System Failure Warning Light
The light illuminates in case of failure of the Enhanced Accident Response System.
Instrument Cluster Indicator Lights
– Turn Signal Indicator
The arrows will flash with the exterior turn signals when the turn signal lever is oper-
ated. A tone will chime, and an instrument cluster display message will appear if either
turn signal is left on for more than 1 mile (1.6 km).
NOTE:
If either indicator flashes at a rapid rate, check for a defective outside light bulb.
– High Beam Indicator
Indicates that headlights are on high beam.
– Glow Plug Indicator Light
This icon blinking indicates that the engine cranking is inhibited in order to prevent pos-
sible engine damage while starting at low temperatures.
– Front Fog Light Indicator
This indicator will illuminate when the front fog lights are on.
154
CAUTION!