System Panel Connector - Asus P5VDC-TVM Manual

11. System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
P5VDC-TVM System Panel Connector
• System power LED (2-pin PLED)
This 2-pin connector is for the system power LED. Connect the
chassis power LED cable to this connector. The system power LED
lights up when you turn on the system power, and blinks when the
system is in sleep mode.
Power LED may remain blinking after AC Power loss or when AC Power
cord is plugged in the first time. Only if turing on-off system normally
one more time.Power Led will not blink afterwards.
• Power/soft-off button (2-pin PWRSW)
This connector is for the system power button. Pressing the power
button turns the system ON or puts the system in SLEEP or SOFT-OFF
mode depending on the BIOS settings. Pressing the power switch for
more than four seconds while the system is ON turns the system OFF.
• Hard disk drive activity LED (2-pin IDELED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD
Activity LED cable to this connector. The IDE LED lights up or flashes
when data is read from or written to the HDD.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for
system reboot without turning off the system power.
1-30
F_PANEL
®
PWRSW
IDE LED RESET
Chapter 1: Hardware information