Above Floor Cleaning; Attachment Assembly; Attachment Usage; Storing Attachments - Dirt Devil Easy Steamer Owner's Manual

Diagram 4
lnsert hose adaptor into dirty
water tank.
ABOVE FLOOR CLEANING
-
TURN BRUSHROLL OFF
(Diagram 1)
1. Put cleaner in its upright position.
2. Remove tools from poly bag. Assemble accordingly. Follow instructions below.
UPHOLSTERYISTAIR ATTACHMENT ASSEMBLY:
1. Connect the upholstery attachment to the trigger adaptor (Diagram 2).
2. REMOVE THE HOSE ATTACHMENT DOOR from the top of the dirty water tank and store in safe place (Diagram 3). lnsert the hose
adaptor into the dirty water tank (Diagram 4) and connect the base water supply connector into the fitting on the lower left side of
handle facing cleaner (Diagram 5 & 5a).
ATTACHMENT USAGE:
1. Turn brushroll off when tools are in use. Switch located on front of cleaner (Diagram 1). Turn power switch on.
2. While depressing solution spray trigger (Diagram 6), pull attachment in backward motion. Release trigger and push attachment forward
in same path to remove dirty water and solution from upholstery. (For heavily soiled areas, repeat if necessary.) NOTE: Do NOT over
saturate the upholstery.
IMPORTANT: FOR BEST CLEANING RESULTS USE STEADY, MODERATE FORWARD AND BACKWARD MOTION.
3. Make sure upholstery is thoroughly dry before use.
4. When finished using attachments, replace hose attachment door onto dirty water tank.
NOTE: If the hose attachment door is not replaced, there will be no suction through the nozzle and the unit will not operate properly.
STORING TOOLS:
lnsert hose and tools into resealable polybag. Store for next use.
HOW TO TRANSPORT UNIT:
Grasp the carrying handle on the back of the unit to move unit from room to room (Diagram 7).
*
DO NOTTRANSPORTTHE EASY STEAMER'" WITH EITHER THE SOLUTION RESERVOIR OR DIRTY WATER TANK FULL.