Mode Command Syntax - Cisco catalyst 6500 series Configuration Note

Configuring SLB Modes
•
•

Mode Command Syntax

Before you can enter CSM configuration commands on the switch, you must specify the CSM that you
want to configure. To specify a CSM for configuration, use the module csm slot-number command. The
slot-number value is the chassis slot where the CSM being configured is located.
The module csm command places you in CSM configuration submode. All additional configuration
commands that you enter apply to the CSM installed in the slot you have specified.
Note Unless otherwise specified, all the examples in this publication assume that you have already entered
this command and entered the configuration submode for the CSM you are configuring.
The command syntax for CSM mode and RP mode configuration is identical with these exceptions:
•
•
To configure a virtual server for a CSM in slot 5, perform this task:
Command
Step 1
Router(config)# module csm 5
Step 2
Router(config-module-csm)# vserver
VS1
This example shows the complete list of CSM commands in the config-module-csm mode.
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# module csm 5
Router(config-module-csm)# ?
SLB CSM module config
arp
capp
default
dfp
exit
ft
map
natpool
no
owner
policy
probe
real
script
serverfarm
static
sticky
variable
vlan
vserver
xml-config
Catalyst 6500 Series Content Switching Module Configuration Note
3-4
Differences Between CSM and RP Modes, page 3-5
Changing Modes, page 3-7
When configuring in CSM mode, you must prefix each top-level command with ip slb.
Prompts are different for CSM mode and for RP mode configurations.
configure a static ARP entry
configure Content Application Peering Protocol
Set a command to its defaults
configure Dynamic Feedback Protocol manager
exit SLB CSM module submode
configure CSM fault tolerance (ft) feature
configure an SLB map
configure client nat pool
Negate a command or set its defaults
configure server owner
configure an SLB policy
configure an SLB probe
configure module real server
configure script files and tasks
configure a SLB server farm
configure static NAT for server initiated connections
configure a sticky group
configure an environment variable
configure a vlan
configure an SLB virtual server
settings for configuration via XML
Purpose
Specifies the location of the CSM you are configuring.
Configures the virtual server.
End with CNTL/Z.
Chapter 3 Getting Started
OL-4612-01