Calculating The Sfc Program Capacity - Mitsubishi MELSEC-Q Series Programming Manual

3 SPECIFICATIONS

3.4 Calculating the SFC Program Capacity

In order to express the SFC diagram using instructions, the memory capacity shown below is
required. The method for calculating the SFC program capacity and the number of steps when the
SFC diagram is expressed by SFC dedicated instructions is described in this section.
(1) Method for calculating the SFC program capacity
Number of steps where SFC diagram is expressed by SFC dedicated instructions.
3 - 28
• Step ( , )
3 sequence steps (+) for step START (STEP
• Transition conditions (+)
1) For serial transition or selective branching coupling
4 sequence steps for transition START instruction (TRAN
destination instruction (TSET Sn).
2) For parallel branching
Total number of steps for the transition START instruction (TRAN
transition destination instructions (TSET Sn) for the number of parallel branches
in question.
3) For parallel coupling
Total number of steps for the transition START instruction (TRAN
the transition destination instructions (TSETSn) and coupling check instructions
(TAND Sn) for the (number of parallel branchings in question 1.
• Jump ( ) , end step (
Calculated as step 0 because it is included in the previous transition condition.
• Operation outputs for each step: The capacity per step is as follows
• Total number of sequence steps for all instructions.
For details regarding the number of sequence steps for each instruction, refer to
the Programming Manual (Common Instructions) for the CPU module used.
• Transition conditions: The capacity per transition condition is as follows
• Total number of sequence steps for all instructions.
For details regarding the number of sequence steps for each instruction, refer to
the Programming Manual (Common Instructions) for the CPU module used.
Sn) and END (SEND) instructions.
)
TRn) and transition
TRn), and
TRn), and
3 - 28