Table of Contents
Advertisement
Appendix B Firmware Upgrade
General information
To be able to perform firmware upgrading, inSentry must be connected to the same
network as the workstation from which the file is to be sent.
In the inSentry Control menu, check that the Network Upgrade is enabled and that
you have the login string information and the Community Read/Write Password.
Updating inSentry Firmware from Windows 9x/Me/NT
4.0/2000/XP
To perform firmware upgrade, use the iupgrade.exe program on the inSentry
CD-ROM. This program is compatible with Windows95/98/Me, Windows NT
3.51/4.0/2000/XP and higher.
1. Sensor Device List: Displays the addresses of the inSentry present in the
local network.
2. Discover: Search for the inSentry on the local network.
3. Add: Lets you add the IP address of a inSentry to the UPS List manually.
4. Modify: Lets you modify the parameters of the inSentry selected in the
inSentry List.
5. Upgrade: Sends the program loaded with the Open button to the selected
inSentry of the inSentry List.
6. Open: Open and load the new image file for upgrade.
7. Remove: Removes the selected inSentry from the inSentry List.
8. Quit: Exit the program.
NOTE: You can simultaneously upgrade up to 4 inSentrys on the network using
the iupgrade.exe program.
40
Advertisement
Table of Contents
