Programming The Interference Eliminator Code - Motorola RDU2020 User Manual

For example:
UHF frequency code 12 = 461.1125 would be programmed as M + SB1 + M + SB1
+ SB1
M gets you to the 10's numeral placement
SB1 gets you to scroll up to the number 1 (only one press)
M confirms your placement & moves you to the units number placement
by pressing SB1 twice you increased the number from 0 to 2
Note: Both LED and Audio beeps will advise user of what number is being
programmed (i.e. 2 = 2 beeps and LED will flash twice)

Programming the Interference Eliminator Code

The Interference Eliminator Code helps minimize interference by
providing you with code combinations, which filter out static, noise,
and unwanted messages.
1. Press M to move to the "Hundreds Digit" of Code, then scroll up
or down using SB1/SB2 to set the "100's" value.
2. Press M to move to the "Tens Digit" of Code, then scroll up or
down using SB1/SB2 to set the "10's" value.
3. Press M to move to the "Units Digit" of Code, then scroll up or down using SB1/
SB2 to set the "1s" value.
Note: Both LED and Audio beeps will advise user of what number is being
programmed (i.e. 2 = 2 beeps and LED will flash twice)
RDX
29