Table of Contents
Advertisement
Moving by Hand
When pushing or pulling the mower, be sure
to engage the EZT (Integraded Zeroturn
Transaxle) bypass linkages. The EZT bypass
linkages are located on the rear of the frame.
•
Raise the deck into the highest cutting
position.
•
Pull the EZT bypass linkages out and
into the slots and release so that it is held
in the bypass position.
•
To reengage the EZT's to drive, reverse
the above procedure.
Load machine into truck or trailer by driving
up ramps in low gear. DO NOT LIFT! This
machine is not intended to be lifted by hand.
OPERATION
1. EZT Bypass linkages
Bypass linkages
1. Head outside of rear deck
2. EZT Bypass linkage in bypass position
Bypass position
8011-721
8011-722
33
English-
Hide quick links:
Advertisement
Table of Contents
