Moving By Hand - Poulan Pro 968999302 Operator's Manual

Moving by Hand

WARNING!
No adjustments or maintenance
to be carried out unless:
- the engine is stopped,
- the ignition key has been
removed,
- the parking brake is on.
When pushing or pulling the mower, be sure
to engage the EZT (Integraded Zeroturn
Transaxle) bypass linkages. The EZT bypass
linkages are located on the rear of the frame.
• Raise the deck into the highest cutting
position.
• Pull the EZT bypass linkages out and
into the slots and release so that it is held
in the bypass position.
• To reengage the EZT's to drive, reverse
the above procedure.
OPERATION
1. EZT Bypass linkages
Bypass linkages
1. Head outside of rear deck
2. EZT Bypass linkage in bypass position
Bypass position
8011-721
8011-722
33
English-