Problems And Solutions - Epson FX-890II User Manual

Panel light state
F Pause
F All the lights on the
control panel
O = on, N= off, F = flashing
= short series of beeps (three beeps)
= long series of beeps (five beeps)
Note:
The printer beeps once if you press a control panel button when the corresponding function is not
available.

Problems and Solutions

Most problems you may encounter while operating your printer have simple solutions. Use the
information in this section to find the source of and solution to printer problems that occur.
Determine the type of problem that occurred, and see the appropriate section below:
"Power supply problems" on page 103
"Paper Handling" on page 108
"Printing position problems" on page 107
"Printing or printout quality problems" on page 103
You can also use the self test to determine whether the printer or the computer is causing the problem.
See "Printing a Self Test" on page 113 for instructions on printing a self test. To pinpoint
communication problems, experienced users may want to use the printer's hex dump mode,
described in "Printing Hex Dump" on page 114.
To clear a paper jam, see "Clearing a Paper Jam" on page 111.
Beep pattern Problem
Solution
– The print head is overheated.
Wait for a few minutes; the printer resumes printing automatically
once the print head cools.
An unknown printer error has occurred.
Turn off the printer and leave it off for several minutes; then turn it on
again. If the error occurs again, contact your dealer.
FX-890II/FX-890IIN/FX-2190II/FX-2190IIN User's Guide
Troubleshooting 102