Trigger Hold Switch; Voltage Control And Digital Meters (For Models With Meters Only) - Miller S-74S Owner's Manual

6-3. Trigger Hold Switch

1 Trigger Hold Switch
Trigger hold allows the operator to weld with-
out holding the gun trigger.

6-4. Voltage Control And Digital Meters (For Models With Meters Only)

1
• To use the trigger hold function, place the
trigger hold switch in the On position.
• The operator must hold the trigger for a mini-
mum of 2 seconds, but not longer than 6
seconds before releasing it. Welding will
continue when the trigger is released.
• To stop welding, press the trigger again.
1 Voltmeter
The voltmeter displays actual or
preset voltage from the welding
power source through the 14−pin
control cable.
2 Wire Speed Meter
The wire speed meter is factory set
to display inches per minute. If dis-
play of meters per minute is de-
1
sired, see Section 5-7.
2
3 Voltage Control
Use control to adjust voltage output
3
of welding power source.
.
You can adjust the preset volt-
age display on the wire feeder
to match your power source's
display by adjusting P2 on mo-
tor control board PC1. See
Section 7-2 for location of P2.
OM-1500-10 Page 21
802828-B
802827-B