Wiremap Displays - Fluke OMNIScanner 2 User Manual

OMNIS User Guide
CANNER
For each of the 8 conductors and the Shield, Wiremap can indicate
proper pin termination on each end, continuity to OMNIR
between any two or more conductors, crossed pairs, reversed pairs,
split pairs, and any other miswiring. For each pair, Wiremap displays
the length. When a pair is faulty the length indicates the distance to
the fault from the OMNIS

Wiremap Displays

The OMNIS
CANNER
end of the cable link.
The OMNIR
EMOTE
OMNIR end of the cable link.
EMOTE
6 - 2
CANNER
icon on the left side indicates the wiring at the OMNI
icon on the right side indicates the wiring at the
CORRECT CONNECTIVITY:
The measured lengths of pairs 1-2, 3-6, 4-5, and
7-8 are shown on the left side of the Wiremap.
If the selected cable is shielded or screened,
shield continuity will be measured, and if the
shield fails the test, Wiremap will display the
error.
WIRE IS OPEN:
Wiremap checks the continuity of each wire.
In this example, there is no line between pin 5 at
each end, which indicates a break in connection.
Use the number on the left side of the screen to
find the exact location of the open. For example
if 36ft is displayed, the open can be found 36ft
away from OMNIS
WIRES ARE SHORTED:
Wiremap finds shorts in the cable being tested.
In this example, the wiremap indicates that wires
4-5 are shorted. Use the number on the left side
of the screen to find the exact location of the
short. For example if 36ft is displayed, the short
can be found 36ft away from OMNIS
end.
.
CANNER
, shorts
EMOTE
.
CANNER