Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Power Up/System Reset
SYSTEM STABILIZATION MODE: Upon power-up of the system and after completion of
system programming, if the system was previously armed, all the lights on the LED
keypad(s) turn ON momentarily or, in the case of an LCD display installation, the keypad(s)
display "STANDBY!" However, the zones will not respond to alarm conditions for
approximately 2 minutes. The 2-minute interval is used to allow motion detectors (interior
zones) to stabilize in order to prevent false alarms. This 2-minute delay can be disabled by
shorting the yellow and black keypad wires (reduces the power-up reset time to
approximately 5 seconds). Upon system power-up, if the system was previously disarmed, the
power-up reset time is approximately 5 seconds. If total system power is lost, upon power
restoral, the system returns to its previously armed state.
Keypads
The FA848C supports the following keypads:
FALCDKP Alpha Keypad
(uses alpha display of system and zone status)
ZONE STATUS LEDS (FALEDKP)
These LEDs display the current zone status, including alarms, bypasses, and faults. Each
condition causes these LEDs to operate differently, as follows:
Fast Blink*:
Slow Blink*:
Flash*:
Solid ON:
OFF:
* See note on next page for definitions of these terms.
FA848C-LCD-V0
Alarms/Tampers.
Troubles, zone low battery if bat LED also lit.
Bypasses; zone bypasses are displayed as a quick flash of the zone LED light.
Faulted Zones. Faulted zones are the lowest priority indication. Faulted
zones are displayed with the LED solidly ON while the system is disarmed.
Normal zone condition.
6\VWHP2SHUDWLRQV
FALEDKP LED Keypad
(uses LEDs to display the status of up to 16 zones)
S E C T I O N
FA848C-LED-V0
5-1
5
Advertisement
Table of Contents
