What To Do If - AEG BE2003021 User Manual

Installing the door and the glass panel

11. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven lamp does not
operate.
2
1
Problem
7. Carefully lift (step 1) and remove
(step 2) the glass panels one by one.
Start from the top panel.
8. Clean the glass panels with water
and soap. Dry the glass panels care-
fully.
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite se-
quence.
Make sure that you put the glass panels
back in the correct sequence. The mid-
dle panel has a decorative frame. The
screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the middle
panel of glass in the seats correctly (refer
to the illustration).
Possible cause
The appliance is deacti-
vated.
The clock is not set.
The necessary settings
are not set.
The fuse in the fuse box
is released.
The oven lamp is defec-
tive.
ENGLISH
Remedy
Activate the appliance.
Set the clock.
Make sure that the set-
tings are correct.
Do a check of the fuse. If
the fuse is released more
than one time, contact a
qualified electrician.
Replace the oven lamp.
21