Maintenance - HoMedics BMSC-2000H-EU Instructional Manual

IB-BMSC2000HEU-0614-01_Layout 1 16/06/2014 10:52 Page 5
INSTRUCTIONS FOR USE :
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with a screw located on the back of the unit to protect the massage
mechanism during shipment, which must be removed before the first use to allow the shiatsu
feature to function. Use the provided Allen key. Then, properly dispose of the screw.
Warning - Failure to remove screw may cause permanent damage to the massager.
Error: all remote control LEDS flash for a few seconds.
Cause: massager overloaded.
Solution: ensure the allen key bolt/screw has been removed from back of the massage cushion
(using the allen key included). Should the condition continue after this please contact your
HoMedics service centre.
NOTE: complete steps 1 to 3 before switching the appliance on at the mains.
1. Attach the Massage seat to almost any chair using the integrated strap located at the back of
the seat. Ensure it is held firmly in place by adjusting the strap as necessary.
2. Connect the power supply, plug the adaptor into a 220-240V AC mains outlet and switch on.
3. Once seated, use the remote control to operate the appliance. Press the
the desired massage zone to start the massage.
4. Press the button to stop the massage.
NOTE:
• There is a 15 minute auto shut-off on this appliance for your safety. This feature should not be
considered as a substitute for 'OFF'. Always remember to switch the appliance off when not
in use.
• The moving Shiatsu mechanism always "parks" or finishes in its lowest position. It will
continue to this position after the power has been turned off. If the electrical supply is
interrupted, when power is restored, the mechanism will "park" or move to its lowest position.

MAINTENANCE :

Cleaning
Cleaning shall not be done by children without supervision.
Unplug the appliance and allow to cool before cleaning. Clean only with a soft, slightly damp
sponge.
• Never allow water or any other liquids to come into contact with the appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place.
Avoid contact with sharp edges or pointed objects which might cut or puncture the fabric
surface. To avoid breakage, DO NOT wrap the power cord around the appliance. DO NOT hang
the unit by the cord.
5
button & select