Show Interface Vlan - Cisco Nexus 5500 Series Command Reference Manual

show interface vlan

show interface vlan
To display brief descriptive information about specified VLANs, use the show interface vlan command.
Syntax Description
vlan-id
brief
private-vlan mapping
Command Default None
Command Modes EXEC mode
Command History Release
5.2(1)N1(1)
Usage Guidelines You must enable interface VLANs by using the feature interface-vlan command. The commands for
configuring interface VLANs are not visible until you enable this feature.
This command displays descriptive information for the specified VLAN, including private VLANs.
The switch displays output for the show interface vlan vlan-id private-vlan mapping command only
when you specify a primary private VLAN. If you specify a secondary private VLAN, the output is
blank.
Examples This example shows how to display information about the specified VLAN:
switch# show interface vlan 10
Vlan10 is up, line protocol is up
Hardware is EtherSVI, address is
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
switch#
This example shows how to display a brief description for the specified VLAN:
switch# show interface vlan 10 brief
-------------------------------------------------------------------------
Interface Secondary VLAN(Type)
-------------------------------------------------------------------------
Vlan10
switch#
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1314
show interface vlan vlan-id [brief | private-vlan mapping]
Number of the VLAN. The range is from 1 to 4094.
(Optional) Displays a summary information for the specified VLAN.
(Optional) Displays the private VLAN mapping information, if any, for the
specified VLAN.
Modification
This command was introduced.
--
0005.9b78.6e7c
Status Reason
up --
Chapter Show Commands
OL-27880-02