Table of Contents
Advertisement
(5) Large Retainer
Springs - 7/16
(2) Smaller Retainer
Springs - 5/16
(1) Anti-Sway Bar
(1) Front Link
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping pur-
poses.
When right or left hand is mentioned in this man ual, it
means from your point of view, when you are in the operat-
ing po si tion (seated be hind the steer ing wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and parts cartons
from carton .
•
Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels fl at.
•
Check for any additional loose parts or cartons and
remove.
CHECK BATTERY (See Fig. 1)
•
Lift hood to raised position.
NOTE: If this battery is put into service after month and year
indicated on label (L) (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
UNASSEMBLED PARTS
Mower
(1) 3/4 O.D. Washers
(5) 1-3/16 O.D. Washers
Assembly
(2) Rear Lift Link
Assemblies
ASSEMBLY
Mower Front Wheel
(1) Wheel
(1) Shoulder Bolt
(1) Oil Drain Tube
For Future Use
Keys
(2) Keys
L
ADJUST SEAT (See Fig. 2)
•
Sit in seat.
•
Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
•
Release lever to lock seat in position.
5
(1) 1-1/4 O.D. Washer
(1) Locknut
3/8-16
Slope Sheet
02931
FIG. 1
Advertisement
Table of Contents
