Onboard I/O Chip Setup - Acer AcerPower APM6 Service Manual

Onboard I/O Chip Setup

Onboard FDC Controller
Onboard Serial Port 1
UART Mode Select
UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
Parameter
Onboard FDC Controller
Onboard Serial Port 1
UR2 Duplex Mode
Onboard Parallel Port
39
Phoenix - Award BIOS CMOS Setup Utility
Onboard Device Setup
[Enabled]
[3F8/IRQ4]
[IrDA]
[Half]
[378/IRQ7]
[SPP]
3
.
Description
Select Enabled if your system has
a floppy disk controller (FDC)
installed on the system board and
you wish to use it. If you install an
add-in FDC or the system has no
floppy drive, select Disabled in this
field.
Select a logical COM port name
and matching address for the
serial port. Select an address and
corresponding interrupt for the
serial port.
In an infrared port mode, this field
appears. Full-duplex mode
permits simultaneous two-
direction transmission. Half-duplex
mode permits transmission in one
direction only at a time. Select the
value required by the IR device
connected to the IR port.
Select a logical LPT port address
and corresponding interrupt for the
physical parallel port.
Item Help
Menu Level
Options
Enabled
Disabled
Chapter 2