Table of Contents
Advertisement
Using The Blower:
1. Remove the blower from packaging. Be
certain no packaging materials are blocking
the air inlet (rear) or air outlet (front).
2. Place blower on level ground.
3. Connect blower to a grounded power outlet
with an approved power rating using a 14
AWG or higher gauge power cord.
Model MAC-700-DR
4. Push power switch on top of blower to the
"ON" position. (Figure 3)
Power Switch
Figure 3
Model MAC-700-DR
4. Turn the control knob to the desired speed: 1,
2, 3. (Figure 4)
Figure 4
NOTE: The direction of moving air is indicated by
an arrow on the blower housing.
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE BLOWER UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE
Operation
Power Knob
4
Moisture Control:
This blower can be used to remove moisture from
an area.
NOTE: This blower will not prevent mold or
mildew formation.
Ventilation:
This blower can move large quantities of air
rapidly to provide ventilation and cooling.
Stacking:
The housing of the MAC-701-DR is designed to
stack one blower on top of another. (Figure 5)
NOTE THE MAC-700-DR DOES NOT STACK.
ALWAYS be certain the blower is on level ground
before stacking.
ALWAYS be certain blowers are stacked properly
and securely before operating.
NEVER stack more than two (2) blowers in a
single stack.
RISK OF INjURy! DO NOT
WARNING
MOVE Blower WHILE
IT IS OPERATING!
Stacked Blowers
(2 Maximum)
Figure 5
Industrial Fan Blower / Dryer User's Manual
Advertisement
Table of Contents
