Safety Information - Master MAC-701-DR User's Manual And Operating Instructions

DO NOT USE TO VENTILATE
DANGER
HARMFUL GASSES OR VAPORS.
This blower is designed to dry damp surfaces
quickly. This blower produces a high-volume
flat air column that increases evaporation. For
best results, be sure to install blower so all damp
surfaces are exposed to the air flow.
Before operating this blower, be sure that
you know how to switch the blower off in an
emergency.
ALWAYS use only the electrical power (voltage and
frequency) specified on the model plate of the blower.
ALWAYS use only three-prong, grounded outlet.
ALWAYS use only 14 AWG or higher gauge
extension cord.
ALWAYS unplug the blower when not in use.
ALWAYS install the blower so that it is not directly
exposed to water spray, rain, dripping water, or wind.
ALWAYS disconnect blower from power source
when not in use.
To Reduce The Risk Of Electric
WARNING
Shock And Injury To Persons,
Do Not Use In A Window.
Use this blower only in the matter intended by the
manufacturer. If you have any questions, contact
Customer Service at 800-641-6996
To reduce the risk of electric
WARNING
shock, connect only to
an outlet provided with a ground fault
interrupting device.
CAUTION – RISK OF ELECTRIC SHOCK
DO NOT OPEN BLOWER SHELL
NO USER-SERVICEABLE PARTS INSIDE
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE BLOWER UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE

Safety Information

2
WARNING
RISK OF ELECTRIC SHOCK!
Do not operate any blower with a damaged cord
or plug. Discard blower or return to an authorized
service facility for examination and/or repair.
If the blower is damaged, do not use it. The
blower must be serviced by a qualified person or
service agent.
When servicing or replacing a component
requires the removal or disconnection of a safety
device, the safety device is to be reinstalled
or remounted as previously installed before
operating this blower
NEVER pull or carry the blower by the
power cord.
NEVER block the air inlet (rear) or air outlet
(front) while in operation.
NEVER insert any objects through the blower
guards.
NEVER use to ventilate harmful, explosive,
flammable or volatile gases, fumes or substances.
This blower produces a strong, constant stream
of air. Before operating blower be sure there are
no unsecured materials that can be blown about
the stream of air.
Minimum Distance From Blower
MAC-700-DR
Front 5 ft
Sides 3.2 ft
Industrial Fan Blower / Dryer User's Manual
MAC-701-DR
1.5 m 5 ft
1 m 3.2 ft
1.5 m
1 m