Getting Started - Vox -01 Operating Manual

3. Getting started

You should receive your VOX-01 with sufficiently charged batteries to start the device and
get acquainted with its features. We do recommend that you fully charge the device using
the supplied charger before starting your first real measurement session.
The device is powered on by pressing the red power button once.
Note: the power button can also be used to power the device off. If you press the button
while the device is in operation, you will see a dialog window asking confirmation before
powering off. If the power button is kept pressed for 10 seconds in the "power on" state,
the device will be forced into the "off " condition. This can be used to reset the device if it
becomes unresponsive (keep pressed to 10 seconds to switch off, then press again to restart).
The VOX-01 will boot into the main menu. You can launch its different modules from this
menu.
STIPA pro : module that gives you access to all STI measurement details
Quick STIPA : simple module to quickly do STIPA measurements
SPL meter : Sound Pressure Level meter module
Settings : change the system's hardware configuration
Calibration : calibrate the VOX-01 and its microphone
Status : general information on the measurement system
All modules will be explained in detail in the following sections of this manual. Apart from
these modules, the VOX-01 has two specific operating modes: charging via USB, and data -
transfer via USB. These modes will also be explained further on in this manual.
VOX
SPEECH INTELLIGIBILITY TESTER
main menu
STIPA quick SPL
pro STIPA meter
settings calibra-
status
tion
Specialized Fire Products
VOX-01 Operating Manual
100%
7