Table of Contents
Advertisement
You can change the Function buttons from their default values so that when the buttons are activated you
can quickly access commonly used menu items.
To assign the Function buttons:
1.
Press one of the four rear bezel buttons to activate the buttons, and then press the Menu button to
open the OSD.
2.
In the OSD menu, select Menu Control > Assign Buttons and then select one of the available options
for the button you want to assign.
NOTE:
You can only assign the three Function buttons. You can not reassign the Menu button or the
Power button.
Using Auto-Sleep Mode
The monitor supports an OSD (on-screen display) menu option called Auto-Sleep Mode that allows you
to enable or disable a reduced power state for the monitor. When Auto-Sleep Mode is enabled (enabled by
default), the monitor will enter a reduced power state when the host PC signals low power mode (absence of
either horizontal or vertical sync signal).
Upon entering this reduced power state (sleep mode), the monitor screen is blanked, the backlight is turned
off and the power light indicator turns amber. The monitor draws less than 0.5 W of power when in this
reduced power state. The monitor will wake from the sleep mode when the host PC sends an active signal to
the monitor (for example, if you activate the mouse or keyboard).
You can disable Auto-Sleep Mode in the OSD. Press one of the four bezel buttons to activate the buttons, and
then press the Menu button to open the OSD. In the OSD menu select Power Control > Auto-Sleep Mode >
Off.
Adjusting Low Blue Light Mode
Decreasing the blue light emitted from the display reduces the blue light exposure to your eyes. HP monitors
provide a setting to reduce blue light output and create a more relaxing and less stimulating image while
you read content on the screen. To adjust your monitor to a comfortable viewing light, follow the steps
below.
To adjust the blue light output from the display:.
1.
Press the Viewing Modes button.
2.
Select your desired setting:
Low Blue Light:(TUV certified):Reduces blue light for improved eye comfort
Reading: Optimizes blue light and brightness for indoor viewing
Night: Adjusts to the lowest blue light and reduces the impact on sleep
3.
Select Save and Return to save your setting and close the Viewing Mode menu. Select Cancel if you
don't want to save the setting.
4.
Select Exit from the Main menu.
WARNING!
To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper
workstation setup, and proper posture, health, and work habits for computer users. The Safety & Comfort
Guide also provides important electrical and mechanical safety information. The Safety & Comfort Guide is
located on the Web at http://www.hp.com/ergo.
14
Chapter 2 Using the monitor
Hide quick links:
Advertisement
Table of Contents
