Using The Auto-Adjustment Function (Analog Input) - HP VH240a User Manual

Using the auto-adjustment function (analog input)

When you first set up the monitor, conduct a Factory Reset of the computer, or change the resolution of the
monitor, the auto-adjustment feature automatically engages, and attempts to optimize your screen for you.
You may also optimize the screen performance for the VGA (analog) input at any time by using the OK/Auto
button on the monitor and the auto-adjustment pattern software utility on the optical disc provided (select
products only).
Do not use this procedure if the monitor is using an input other than VGA. If the monitor is using a VGA
(analog) input, this procedure can correct the following image quality conditions:
• Fuzzy or unclear focus
• Ghosting, streaking, or shadowing effects
• Faint vertical bars
• Thin, horizontal scrolling lines
• An off-center picture
To use the auto-adjustment feature:
1. Allow the monitor to warm up for 20 minutes before adjusting.
2. Press the Menu button on the monitor, and then select Image Control > Auto Adjustment from the
OSD menu. If the result is not satisfactory, continue with the procedure.
3. Open the Auto-Adjustment utility from the optical disc, if one is provided with the monitor.
4. Select Open Auto-Adjustment Utility. The setup test pattern is displayed.
5. Press the OK button on the monitor to produce a stable, centered image.
6. Press the
NOTE: The auto-adjustment test pattern utility can be downloaded from http://www.hp.com/support.
16 Chapter 3 Support and troubleshooting
ESC key or any other key on the keyboard to exit the test pattern.