Freezer Compartment - AEG SANTO N 8 18 40-4 i Operating And Installation Instructions

Integrating fridge freezer
Hide thumbs Also See for SANTO N 8 18 40-4 i:
Table of Contents

Advertisement

Open the door and push the
appliance against the side of the
kitchen unit opposite to that of
appliance hinges.
Fasten the appliance with 4
screws provided in the kit
included with the appliance.
Snap vent grille (C) and hinge
cover (D) into position.
Apply covers (B) on joint cover lugs
and into hinge holes.
Separate parts A, B, C, D as shown in
the figure
34
D
C
D723
B
D726
B
A
C
D
PR266
Starting up and temperature regulation of

freezer compartment

• Turn the temperature regulator (B) in the direction of "1". The green(A)
comes on. The freezer motor starts up.
• Psuh the
Normal/Super push button
Setting "0": Off.
Setting "1": Hightest temperature, (warmest setting).
Setting "4" (end-stop) : Lowest temperature, (coldest setting).
The exact setting should be chosen keeping in mind that the temperature
inside the appliance depends on:
- the quantity of food stored
- how often the door is opened
- ambient temperature
Quick-freezing
For quick-freezing, push the Normal/Super button (D). The super
control light (C) will then light up.
The Quick-freezing function accelerates the freezing of fresh food
and, at the same time, protects foodstuffs already stored from
undesirable warming.
If this function is not ended manually, the appliance switches off
the Quick-freezing function after 52 hours. The yellow light goes
out.
This function can be ended manually at any time by pressing the
Normal/Super button again. The yellow light goes out.
(D), the yellow light (B) comes on;
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents