Chapter 4: Connecting The Wireless-G Ethernet Bridge For Setup; Figure 4-1: Connect To The Network; Figure 4-2: Connect The Power - Linksys WET54G v3 Quick Installation Manual

Wireless-G Ethernet Bridge
Chapter 4: Connecting the Wireless-G Ethernet Bridge for
Setup
1. Attach the Bridge's antenna.
2. Plug the included Ethernet network cable into the LAN port on the back panel of the Bridge, shown in Figure
4-1.
3. Plug the other end of the Ethernet network cable into the RJ-45 port of the hub, switch, or PC you wish to use
to configure the Bridge.
4. Plug the supplied power cable into the Power port on the back panel of the Bridge, shown in Figure 4-2. Then
plug the other end into an electrical outlet.
5. The Power LED will light up after the Bridge is powered on. While the Bridge is booting up and performing a
self-test, the Power LED will flash. It should stop flashing within twenty seconds and remain lit.
Proceed to "Chapter 5: Setting Up the Wireless-G Ethernet Bridge."

Chapter 4: Connecting the Wireless-G Ethernet Bridge for Setup

Figure 4-1: Connect to the Network

Figure 4-2: Connect the Power

8