Lexus LC500h 2017 Owner's Manual page 93

■
Programming HomeLink
1
Press and release the HomeLink
®
HomeLink indicator light flashes (orange).
3
Perform within 60 seconds of
ming will not be able to be completed.
 For U.S.A. owners
 Programming an entry gate (for U.S.A. owners)/Programming a device in the Cana-
dian market
3
Press and release the remote control transmitter button at 2 second intervals, repeat-
edly, until the HomeLink
idly flashing (green) (rolling code) or continuously lit (green) (fixed code).
4
Test the HomeLink
ing the indicator light:
● Device with fixed code: If the indicator light is solid/continuous, programming has
been completed and your garage door or other device should operate when the
HomeLink
● Device with rolling code: If the indicator light flashes rapidly, your garage door
opener motor (or other device) is equipped with a rolling code. Complete the pro-
gramming process by firmly pressing and holding the programmed HomeLink
button for 2 seconds and then release the button.
● If the garage door or other device does not operate, proceed to "Programming a
rolling code system".
93
LC500_LC500h_QG_OM11444U_(U)
®
®
button you want to program and check that the
1
, or the indicator light will stop flashing and program-
®
indicator light changes from slowly flashing (orange) to rap-
®
operation by pressing the newly programmed button and observ-
®
button is pressed and released.
2
Point the remote control transmitter
for the device at the rear view mirror,
1 to 3 in. (25 to 75 mm) from the
®
HomeLink buttons.
®
Keep the HomeLink
view while programming.
3
Press and hold the handheld transmit-
ter button until the HomeLink
tor light changes from slowly flashing
orange to rapidly flashing green (roll-
ing code) or continuously lit green
(fixed code), then release the button.
indicator light in
®
indica-
®