Initializing the tire pressure warning system
1
Turn the engine switch <power switch> to IGNITION ON mode <ON mode>.
2
Press
or
3
Press
or
press "OK".
4
Press
or
"OK".
5
Press
or
press and hold "OK" until the tire pressure warning light starts blinking.
6
Drive the vehicle at approximately 25 mph (40 km/h) or more for approximately 10 to
30 minutes.
When initialization is complete, the inflation pressure of each tire will be displayed on
the multi-information display.
LC500_LC500h_QG_OM11444U_(U)
of the meter control switches and select
of the meter control switches and select "Vehicle Settings", then
of the meter control switches and select "TPWS SET", then press
of the meter control switches and select "Set tire pressure". Then
A message is displayed on the multi-infor-
mation display. Also, "--" is displayed for
inflation pressure of each tire on the multi-
information display while the tire pressure
warning system determines the position.
.
56