Fixing Screw "A - Central Machinery 34102 Assembly And Operating Instructions Manual

FIXING SCREW "A" (#6)

FIXING SCREW "B" (#7)
BRACKET
FRAME (#16)
COMB TABLE (#18)
BOLT (#3)
STOP PIN
(#19)
FIXING SCREW "B" (#7)
ECCENTRIC ROD (#13)
5. Tighten the two rear Fixing Screws "B" (part #7), and pull down on the rear
Eccentric Rod (part #13) to clamp the horizontal wood stock in place.
(See Figure D, next page.)
6. Insert the second piece of wood stock (from 5-13/16" to 10-7/8" wide) vertically
from below, between the front Bracket Frame (part #16) and the vertical edge of
the Working Table (part #1). NOTE: The top edges of the two workpieces should
be flush. (See Figure C.)
7. IMPORTANT: The vertical wood stock should be positioned offset to the left of
the horizontal wood stock by the width of one Comb on the Comb Table (part
#18). (See Figure C.)
8. If necessary, adjust the forward/backward position of the Comb Table (part #18)
until the tips of the Combs are approximately 5/32" clear of the vertical wood
stock's edge. To do so, slightly loosen the two Fixing Screws "A". Move the
Comb Table inward or outward until it is properly positioned. Then, retighten the
Fixing Screws "A". (See Figure D.)
9. Adjust the width of the four Stop Pins (part #19) so that they touch the two pieces
SKU 34102
SPACING SCREW (#8)
ECCENTRIC ROD (#13)
WOOD STOCK
WOOD STOCK
FIXING SCREW "B" (#7)
PAGE 7
SPACING SCREW (#8)
FIXING
SCREW "A" (#6)
FIXING
SCREW "B"
(#7)
BOLT (#3)
STOP
PIN (#19)
BOLT (#3)
STOP PIN (#19)
WORKING TABLE (#1)
BRACKET FRAME (#16)
FIGURE C