Central Machinery 34102 Assembly And Operating Instructions Manual page 5

ROTARY ROD (#11)
ECCENTRIC ROD (#13)
To Mount The Dovetail Joint Fixture On A Workbench:
1. CAUTION: Make sure the Dovetail Joint Fixture is mounted on a flat, level,
sturdy, workbench capable of supporting the weight of the Dovetail Joint Fixture,
workpieces, and tools.
2. NOTE: It is necessary to mount the Dovetail Joint Fixture on the front edge of
the workbench, so that the front tab of the Working Table (part #1) rests against
the vertical edge of the workbench. (See Figure B, next page.)
3. To mount the Dovetail Joint Fixture, use the two mounting holes located at each
end of the Work Table (part #1). (See Figure B.)
4. Position the Dovetail Joint Fixture at the desired location on the workbench.
Mark and drill four 3/16" holes in the workbench, using the two mounting holes at
each end of the Dovetail Joint Fixture as a template. Then secure the Dovetail
Joint Fixture to the workbench, using four wood screws (not included).
(See Figure B.)
SKU 34102
ROTARY ROD (#11)
KNOB (#12)
ECCENTRIC ROD (#13)
WOOD STOCK
PAGE 5
KNOB (#12)
WOOD STOCK
WORKING TABLE (#1)
ROD FIXER (#23)
FIGURE A