Controlling The Volume; Led Display - Jensen SMPS-750 User Manual

This unit features a MASTER VOLUME CONTROL (#18) located on the main unit. The
output volume level is initially controlled based on where this control is set.
It's important that if you use the remote control to adjust the volume, make sure the MASTER
VOLUME CONTROL (#18) is always set to maximum prior to using the remote control.
Note: If the MASTER VOLUME CONTROL (#18) is set below the maximum volume level,
the output volume level will be reduced if you use the remote control. Example: if the
MASTER VOLUME CONTROL (#18) is set to 50%, you will only be able to adjust between
0 and 50% of the full volume when using the remote control.
When using the remote control to adjust the volume level, you will notice that the LED display
shows V00-V30 as you adjust the volume level. V00 meaning the lowest volume level, and
V30 is maximum. Make sure the volume level on the remote control is always left at V30 if
you decide to switch to using the MASTER VOLUME CONTROL (#18) instead of the remote
control. Leaving the remote control volume level set below V30 will reduce the audio output
on the SMPS-750. Turning the POWER SWITCH (#19) OFF and then ON again will reset
the volume control setting in the main unit, and restore full use of the MASTER VOLUME
CONTROL (#18).
The LED display will show the following codes when that feature is active.
= displays when you are in BLUETOOTH mode
LInE = displays when you are in AUX mode
OnE = displays when "Repeat One" is selected during playback
= displays when "Repeat ALL" is selected during playback
bt
= displays when "No Repeat" is selected during playback
6 Preset EQ Settings - Only accessible when using the "EQ" button on the remote control
ALL
= displays when "NORMAL" EQ setting is selected
nOr
POP = displays when "POP" EQ setting is selected
= displays when "ROCK" EQ setting is selected
= displays when "JAZZ" EQ setting is selected
nOr
CLA = displays when "CLASSIC" EQ setting is selected
= displays when "COUNTRY" EQ setting is selected
rOC
JAZ
Note: The preset EQ settings are only available when in Bluetooth or USB/SD modes.
Volume Level – Only shows when using the "VOLUME" buttons on the remote control V00
Cut
to V30
Note: The volume level range controlled by the remote control is limited by the MASTER
VOLUME CONTROL (#18). The MASTER VOLUME CONTROL (#18) should be set around
the half way point on the dial before you first power up the unit.

CONTROLLING THE VOLUME

LED DISPLAY

E-7