Table of Contents
Advertisement
RUGGEDCOM RSG2488
Installation Guide
•
Section 3.3.2, "Removing an SFP Optical Port"
Section 3.3.1
Installing an SFP Optical Port
To install an SFP optical port, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Use only components certified by RuggedCom with
RuggedCom products. Damage to the module and device may occur if compatibility and reliability have
not been properly assessed.
CAUTION!
Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated
before installing or removing components from the device. An electrostatic discharge (ESD) can cause
serious damage to the component once it is outside the chassis.
1.
Make sure all potential electrostatic build-up has been propery discharged to prevent electrostatic discharges
(ESD). This can be accomplished by wearing an ESD wrist strap or by touching Earth or the chassis ground.
2.
Remove the dust cover from the port slot and insert the port.
Figure 29: Installing an SFP Optical Port
1. SFP Optical Port
3.
Connect a cable to port and test the connection.
Section 3.3.2
Removing an SFP Optical Port
To remove an SFP optical port, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated before
performing installing or removing components from the device. An electrostatic discharge (ESD) can
cause serious damage to the component once it is outside the chassis.
1.
Make sure all potential electrostatic build-up has been propery discharged to prevent electrostatic discharges
(ESD). This can be accomplished by wearing an ESD wrist strap or by touching Earth or the chassis ground.
2.
Disconnect the cable from the port.
Installing an SFP Optical Port
2. Metal Bail-Latch
1
2
Chapter 3
Modules
19
Advertisement
Table of Contents
