Interlocks And Relays - Poulan Pro 182080 Owner's Manual

14.5 hp 42 inch lawn tractor
Table of Contents

Advertisement

POSITIVE TERMINAL
CHASSIS
POSITIVE
TERMINAL
Connect one end of the BLACK cable to the NEGATIVE
(-) terminal of fully charged battery.
Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
BLACK cable first from chassis and then from the fully
charged battery.
RED cable last from both batteries.
REPLACING BATTERY (See Figs. 26 and 27)
CAUTION: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
Lift seatpan to raised position.
Disconnect BLACK battery cable first then RED battery
cable and carefully remove battery from tractor.
Install new battery with terminals in same position as old
battery.
First connect RED battery cable to positive (+) terminal
with hex bolt and keps nut as shown. Tighten securely.
Slide terminal cover over terminal.
Connect BLACK grounding cable to negative (-) terminal
with remaining hex bolt and keps nut. Tighten securely.
SEAT PAN
SERVICE AND ADJUSTMENTS
NEGATIVE TERMINAL
CABLES
NEGATIVE
TERMINAL
CHARGED
BATTERY
FIG. 25
FIG. 26
POSITIVE (RED)
CABLE
TO REPLACE HEADLIGHT BULB
Raise hood.
Pull bulb holder out of the hole in the backside of the grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring. See electrical wiring diagram in the Repair
Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse. The fuse
holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 28)
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
To replace, reverse above procedure.
22
KEPS
NUT
NEGATIVE
(BLACK) CABLE
FIG. 27
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 28
HEX
BOLT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Po14542e

Table of Contents