Alarm Group Configuration Example - HP MSR Series Configuration Manual

multicast packets : 6
undersize packets : 0
fragments
collisions
Sampled values of record 7 :
dropevents
packets
multicast packets : 6
undersize packets : 0
fragments
collisions
Sampled values of record 8 :
dropevents
packets
multicast packets : 6
undersize packets : 0
fragments
collisions
: 0
# On the configuration terminal, get the traffic statistics through SNMP. (Details not shown.)

Alarm group configuration example

Network requirements
Configure the RMON alarm group on the RMON agent in
5-second incoming traffic statistic on Ethernet 1/1 crosses the rising threshold or drops below the falling
threshold.
Figure 9 Network diagram
Configuration procedure
# Configure the SNMP agent with the same SNMP settings as the NMS at 1.1.1.2. This example uses
SNMPv1, read community public, and write community private.
<Sysname> system-view
[Sysname] snmp-agent
[Sysname] snmp-agent community read public
[Sysname] snmp-agent community write private
[Sysname] snmp-agent sys-info version v1
[Sysname] snmp-agent trap enable
: 0
: 0
: 0
: 7
: 0
: 0
: 0
: 13
: 0
, utilization
, CRC alignment errors : 0
, oversize packets
, jabbers
, utilization
, octets
, broadcast packets
, CRC alignment errors : 0
, oversize packets
, jabbers
, utilization
, octets
, broadcast packets
, CRC alignment errors : 0
, oversize packets
, jabbers
: 0
Figure 9
21
: 0
: 0
: 0
: 766
: 0
: 0
: 0
: 0
: 1154
: 1
: 0
: 0
to send alarms in traps when the