Using The Display Option - Kodak 9500 User Maintenance Manual

Using the
Display option
Using the %KODAK
option
8-18
The Display option allows you to display the decoded value of an
individual bar code as it is fed into the transport. After selecting Option
2, DISPLAY, feed a bar code document.
To verify that a bar code is decoded properly:
1. Select 2=DISPLAY.
Bar Code Type =
1=EVALUATE 2=DISPLAY
One of the following messages will be displayed:
•
Bar code was not read.
If the display indicates the bar code was not read, it could be for
one of the following reasons:
◊
The type of bar code read was not the type indicated in the
status display.
Action: Verify the type of bar code read.
◊
The bar code quality is poor.
Action: Perform the required maintenance.
•
?
This display indicates the start character was recognized, but the
remainder of the bar code was unreadable.
Action: Perform the required maintenance.
•
Decoded bar code value
This display gives the decoded value of the bar code read.
2. When the test is completed, press C to return to normal operation, or
press Stop to remain in the test environment.
The %KODAK test option establishes the percentage of bar codes
properly read when using Kodak Bar Code Standard Test Documents.
This option is designed to provide a baseline value as well as the
current read rate. A comparison of the two values provides a measure
of machine performance over time.
To use the %KODAK test option:
1. Select 3=%KODAK.
Bar Code Type =
1=EVALUATE 2=DISPLAY
2. Feed at least 100 Kodak test documents. As documents are fed into
the transport, the Kodak documents fed value will increment.
Kodak documents fed = 100
Current = xx.x%
Historical = xx.x%
3=%KODAK 4=%NORM
3=%KODAK 4=%NORM
A-61092 September 1999