Limbing And Pruning - Poulan Pro 230 Operator's Manual

down area. Drag the logs into a clear area
before cutting by pulling out exposed and
cleared logs first.
TYPES OF CUTTING USED FOR
BUCKING
WARNING:
If saw becomes pinched
or hung in a log, don't try to force it out. You
can lose control of the saw resulting in injury
and/or damage to the saw. Stop the saw,
drive a wedge of plastic or wood into the cut
until the saw can be removed easily. Restart
the saw and carefully reenter the cut. To
avoid kickback and chain damage, do not
use a metal wedge. Do not attempt to restart
your saw when it is pinched or hung in a log.
Use a wedge to remove pinched saw
Turn saw and use a plastic or
OFF
wooden wedge to force cut open.
Overcutting begins on the top side of the log
with the bottom of the saw against the log.
When overcutting use light downward pres-
sure.
Overcutting Undercutting
Undercutting involves cutting on the under-
side of the log with top of saw against the log.
When undercutting use light upward pres-
sure. Hold saw firmly and maintain control.
The saw will tend to push back toward you.
WARNING:
Never turn saw upside
down to undercut. The saw cannot be con-
trolled in this position.
Always make your first cut on the compres-
sion side of the log. The compression side of
the log is where the pressure of the log's
weight is concentrated.
First cut on compression side of log
Second cut
Second cut
First cut on compression side of log
BUCKING WITHOUT A
SUPPORT
S Overcut through of the diameter of the
1/3
log.
S Roll the log over and finish with a second
overcut.
S Watch for logs with a pressure side to pre-
vent the saw from pinching. See illustra-
tion for cutting logs with a pressure side.
BUCKING USING A LOG OR
SUPPORT STAND
S Remember your first cut is always on the
pressure side of the log.
(Refer to the illustration below for your first
and second cut)
S Your first cut should extend
diameter of the log.
S Finish with your second cut.
Using a log for support
nd
2 Cut
st
1 Cut
nd
2 Cut
Using a support stand
nd
2 Cut
st
1
Using a support stand
st
1 Cut
nd
2 Cut

LIMBING AND PRUNING

WARNING:
Be alert for and guard
against kickback. Do not allow the moving
chain to contact any other branches or ob-
jects at the nose of the guide bar when limb-
ing or pruning. Allowing such contact can re-
sult in serious injury.
11
of the
1/3
st
1 Cut
Cut