Maintenance - Poulan Pro 115259926 Instruction Manual

CUSTOMER RESPONSIBILITIES
WARNING:
Disconnect power source before performing maintenance.
Fill in dates as you complete
regular service
Check for damaged/worn parts
Check for loose fasteners/parts
Check chain tension
Check chain sharpness
Check guide bar
Check bar and chain oil level
Inspect and clean unit & labels
Clean guide bar groove
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover
items that have been subjected to oper-
ator abuse or negligence. To receive full
value from the warranty, the operator
must maintain unit as instructed in this
manual. Various adjustments will need
to be made periodically to properly
maintain your unit. Improper mainte-
nance may cause damage to the unit
and possible injury to the operator or by-
standers.
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for
replacement of worn or damaged parts.
NOTE: It is normal for a small amount of
oil to appear under the saw after motor
stops. Do not confuse this with a leaking
oil tank.
S Trigger Switch -- Ensure the trigger
switch functions properly by squeezing
and holding the trigger switch. Make
sure motor starts and stops.
S Oil Tank - - Discontinue use of chain saw
if oil tank shows signs of damage or
leaks.
S Extension Cord - - Discontinue use if
chain saw extension cord shows signs
of damage or wear.
CHECK FOR LOOSE FASTENERS
AND PARTS
S Bar knob
S Chain
S Housing screws

MAINTENANCE

Before After
Use Use
n
n
n
n
n
n
n
n
CHECK CHAIN TENSION
WARNING:
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
Chain tension is very important. Chain
stretches during use. This is especially
true during the first few times you use your
saw. Always check chain tension each
time you use your saw.
1. Unplug unit from the power source.
2. Use a screwdriver to move chain
around guide bar to ensure kinks do
not exist. The chain should rotate
freely.
3. Lift lever on bar knob and turn coun-
terclockwise 1 turn to loosen bar
clamp.
4. Turn adjusting wheel (downward di-
rection) to tension chain until chain
solidly contacts bottom of guide bar
rail. Lift tip of guide bar while adjust-
ing tension.
12
Every Service
15 min. Dates
n
Wear protective
LOOSEN